Message #17704

[Svend]

It costs a bit more, but I've gone roto - roto-cork and roto-brushes.  Full wax job in less than 10 minutes - no iron or scraping  required - just a handy power drill with speed control.  I use up a lot less wax too.

OK -- details please! 
-- Brand of brushes preferred?
-- How do you get the wax to penetrate deep into the bases without the iron? Cork, of course, but does it last? Isn't iron-in better for penetration and durability?
-- What method? Crayon the wax on; roto-cork it in; brush off....?

I'm looking to go Rotobrush too, but was thinking of using the roto brushes only after the Fiberlene hot wax application.  No iron sounds appealing, if the wax job is a good one and lasts as long as a hot wax.  Looking forward to hearing about this....

Thanks!